Activating a Go Device

Activating a Go Device

This article explains how to activate a GO device once installed.
  1. Once installed, a GO device needs to record 150 logs within one single connection to the servers and an ignition OFF event in order to activate and start getting billed. This would normally be a trip of about 10-15 minutes in an area of good cell coverage.


    • Related Articles

    • Move Go device to a new vehicle

      Please follow the below steps to correctly move the device between vehicles : Steps Physically unplug the GO device from the old vehicle In the MyGeotab database, click on Vehicles Select the old vehicle from which you just unplugged the GO device ...

    • MyGeotab - Activate Geotab Device

      This article explains how to activate a Geotab device. Procedure Once the Geotab Device is installed in a vehicle:       1. Take a vehicle in-which a Go Device is installed       2. Take it on a 10 - 15 minute trip in an area with good cellular ...

    • Add device in Mygeotab

      Please follow the below steps to add a device in MyGeotab database. Steps Login to Mygeotab database Go to Vehicles Click on Add> Add device Enter serial number and Description Click Ok

    • IOX-GO TALK device setup

      My IOX-GO TALK device is not speaking audible alerts when rule exceptions are triggered. How do I configure/integrate my IOX-GO TALK into my Geotab database? Please perform the installation of the GOTALK  as mentioned on page 2 of this document:  ...

    • Move Go device to a new vehicle

      Please follow the below steps to correctly move the device between vehicles : Steps Physically unplug the GO device from the old vehicle In the MyGeotab database, click on Vehicles Select the old vehicle from which you just unplugged the GO device ...