Connect the dashcam to a power source - Z6
Procedure:
To utilize the full features of the Z6 dashcam, including Standby mode, your dashcam must be connected to a constant 12V or 24V minimum 2A power source. The dashcam should only be connected to a power source using the supplied cables.
The input power connector is located on the side of the dashcam cylinder.
​
Note: USB-C can NOT be used to power the dashcam.
You can connect the dashcam to a power source as follows:
Note: The dashcam turns on and records once your vehicle starts moving.
Related Articles
MyGeotab - Battery Drain
This article explains what each type of wire means, as well as how to use it properly. Black The GROUND wire; it must be connected to a known good chassis ground. Yellow The ignition sense wire; it must be connected to a true ignition source (live ...
MyGeotab - Setup PTO Rule
This article explains how to setup the PTO rule in MyGeotab. Steps 1. Log in to database 2. Navigate to 'Rules & Groups' > 'Rules' 3. Click on 'Add' 4. Give the name to 'Rule' and navigate to 'Conditions' 5. Select 'Add ...
The AI-12 Dashcam Settings on MyGeotab
To set up the Surfsight AI-12 Dashcam, follow these steps. 1. Click on the 'Surfsight Add-In' on the left bar. Then click on the 'Vehicles' in the sub-menu. 2. On the 'Vehicles' page, click on the 'Settings' button next to the vehicle ...
MyGeotab - PTO data from Engine
Steps 1. Login to MyGeotab 2. Navigate to 'Engine & Maintenance' > 'Engine and Devices' > 'Measurements' 3. Select 'Date Period' 4. Select 'Vehicles' 5. Under Diagnostics type 'PTO' and select all the Diagnosis for PTO ...
Assign the Surfsight AI-12 Dashcam to a Vehicle on MyGeotab
Once the Surfsight Add-In is configured on the MyGeotab platform, we can assign the Surfsight AI-12 Dashcam to the MyGeotab account. Please note: the Geotab security clearance affects the users’ provisioning and management of the Surfsight Dashcam. ...