This article explains what each type of wire means, as well as how to use it properly.
Black
The GROUND wire; it must be connected to a known good chassis ground.
Yellow
The ignition sense wire; it must be connected to a true ignition source (live with the key in both the ON and RUN positions, dead when the key is off). Fuse size is 1 A.
Red
The constant power (12V or 24V) wire; it must be connected to a true battery source (live at all times). Fuse size is 5 A.
The red and yellow wires must connect to a fused source, or the user must install the fuses.
If the vehicle is experiencing battery drain issue caused by Geotab device , check for Engine Faults . If there are any faults reported for the unit e.g multiple faults for Telematics device removed , unplugged or restarted , Please collect the ...
This article explains how to check battery percentage of a beacon device. Steps 1. Login to Mygeotab > Go to bewhere dashboard 2. Now click on Beacons 3. Scroll to the right side and click on battery option 4. The ...
This article explains how to setup the PTO rule in MyGeotab. Steps 1. Log in to database 2. Navigate to 'Rules & Groups' > 'Rules' 3. Click on 'Add' 4. Give the name to 'Rule' and navigate to 'Conditions' 5. Select 'Add ...
NOTE: The CAN Box Transceiver (A) needs to be installed near the G06 Unit (“H” in Diagram below). ‣ Connect the supplied Valor Wire Harness (B) to the CAN Box Transceiver (A). ‣ Connect the other end of the supplied Valor Wire Harness (B) to the ...
NOTE: The CAN Box Transceiver (A) needs to be installed near the G06 Unit (“H†in Diagram below). ‣ Connect the supplied Valor Wire Harness (B) to the CAN Box Transceiver (A). ‣ Connect the other end of the supplied Valor Wire Harness ...