SIM card loacation in Falcon

Procedure:

The Falcon uses a micro SIM card – form factor 3FF. The SIM holder is on the underside of the control board, so the device will need to be unscrewed and lifted out of the housing to insert the SIM.

When handling the Falcon be careful not to touch the GPS antenna, to minimize the risk of damaging the sensitive GPS amplifiers with static discharge.


Then open the SIM holder by sliding towards the edge of the board, and place the SIM with the keyed corner facing in and the SIM contacts orientated down to the main board. Then gently press the SIM cover back down and slide towards the middle of the board to latch.

​

• Related Articles

• Activating a Go Device

  This article explains how to activate a GO device once installed. Once installed, a GO device needs to record 150 logs within one single connection to the servers and an ignition OFF event in order to activate and start getting billed. This would ...

• MyGeotab - Activate Geotab Device

  This article explains how to activate a Geotab device. Procedure Once the Geotab Device is installed in a vehicle:       1. Take a vehicle in-which a Go Device is installed       2. Take it on a 10 - 15 minute trip in an area with good cellular ...

• Add device in Mygeotab

  Please follow the below steps to add a device in MyGeotab database. Steps Login to Mygeotab database Go to Vehicles Click on Add> Add device Enter serial number and Description Click Ok

• Move Go device to a new vehicle

  Please follow the below steps to correctly move the device between vehicles : Steps Physically unplug the GO device from the old vehicle In the MyGeotab database, click on Vehicles Select the old vehicle from which you just unplugged the GO device ...

• Add Device - Trax ZenduCam

  This article demonstrates the steps to follow to add a device in Trax ZenduCAM. Only Admins will have access to adding the device. Steps       1. Login to ZenduCam/Trax where you have the ZenduCam Add-in       2. Click on 'Admin'             3. Click ...